Blenders

Waring Laboratory Blenders 

8010S/8010G

• Capacity: 1 litre/1.2 litres
• Switch Settings: two speed, 3 minute mechanical timer
• Base: Die cast epoxy coated base
• Container: Stainless steel with handle and two-piece vinyl and styrene lid – 8010S. Heat-resistant glass with handle and two-piece vinyl and styrene lid – 8010G.
• Overall height: 38/40.5cm

8011S/8011G

• Capacity: 1 litre/1.2 litres
• Switch Settings: two speed
• Base: Die cast epoxy coated base
• Container: Stainless steel with handle and two-piece vinyl and styrene lid – 8011S. Heat-resistant glass with handle and two-piece vinyl and styrene lid – 8011G.
• Overall height: 38/40.5 cm

Variable Speed Lab Blender  – LB20ES/LB20EG

• Capacity: 1 litre/1.2 litres
• Switch Settings: Variable speed 0 – 20,000 RPM, for mixing, stirring, blending, or homogenising
• Base: Die-cast epoxy coated base
• Container: Stainless steel with handle and two-piece vinyl and styrene lid – LB20ES. Heat-resistant glass with handle and two-piece vinyl and styrene lid –  LB20EG (pictured)

4 lt Commercial Blender CB15E

• Capacity: 4 litres
• Switch settings : Off, Low, Med, High and Pulse
• Rating: 230 volts – 50/60Hz – single phase, 7.5 amps
• Base : Die cast grey epoxy coating with electronic membrane keypad
• Container: Stainless steel with s/s blades, s/s clamp on lid with rubber gaskets and stopper
• Bearing: High performance bearings

Two-speed, 2 litre Model, HGB55E

• Capacity: 2 litres.
• Switch Setting: two speed,  Low speed approximately 19000rpm, high speed approximately 23000rpm (without load).
• Ratings:  230V 50Hz single phase supplies
• Base: Stainless steel  neoprene coated steel, drive coupling to motor,   giving reduced wear.,
• Overall: 165mm diameter x 480mm high.

Hazardous Location Blender Motor BHL240

• Capacity: 1 litre
• Switch Settings: Two-speed switch available as an accessory – BHLSW
• Container: 1-litre stainless steel with stainless lid available separately – HL515
• Cord: not included.  Must be hard-wired via explosion-proof   conduit.
• Overall height: 37.5 cm
• Weight: 8.62k
• UL Listed for use in Class 1, Group D hazardous locations

HL515 – One-Litre Stainless Steel Container

Stainless steel container and lid with special teflon seals and blending assembly for BHL240.

Please note that the BHL240 will lose Class D Explosion Resistant Rating if not used with this container.